The recognition of former melt flux through high‐strain zones          下载免费PDF全文

Catherine A. Stuart  Sandra Piazolo  Nathan R. Daczko 《Journal of Metamorphic Geology》2018,36(8):1049-1069

High‐strain zones are potential pathways of melt migration through the crust. However, the identification of melt‐present high‐strain deformation is commonly limited to cases where the interpreted volume of melt “frozen” within the high‐strain zone is high (>10%). In this contribution, we examine high‐strain zones in the Pembroke Granulite, an otherwise low‐strain outcrop of volcanic arc lower crust exposed in Fiordland, New Zealand. These high‐strain zones display compositional layering, flaser‐shaped mineral grains, and closely spaced foliation planes indicative of high‐strain deformation. Asymmetric leucosome surrounding peritectic garnet grains suggest deformation was synchronous with minor amounts of in situ partial melting. High‐strain zones lack typical mylonite microstructures and instead display typical equilibrium microstructures, such as straight grain boundaries, 120° triple junctions, and subhedral grain shapes. We identify five key microstructures indicative of the former presence of melt within the high‐strain zones: (a) small dihedral angles of interstitial phases; (b) elongate interstitial grains; (c) small aggregates of quartz grains with xenomorphic plagioclase grains connected in three dimensions; (d) fine‐grained, K‐feldspar bearing, multiphase aggregates with or without augite rims; and (e) mm‐ to cm‐scale felsic dykelets. Preservation of key microstructures indicates that deformation ceased as conditions crossed the solidus, breaking the positive feedback loop between deformation and the presence of melt. We propose that microstructures indicative of the former presence of melt, such as the five identified above, may be used as a tool for recognising rocks formed during melt‐present high‐strain deformation where low (<5%) volumes of leucosome are “frozen” within the high‐strain zone.  相似文献   

Effect of sand on the vacuum consolidation of dredged slurry     

Jun Wang  Yuanqiang Cai  Xueyu Geng  Fengqi Xu 《Marine Georesources & Geotechnology》2018,36(2):238-244

Vacuum preloading is often used to improve the geotechnical properties of dredged slurry. Although the performance of this method has improved with rapidly developing technology, soil columns usually formed on the drainage boundary induce the decrease of permeability around the boundary, thereby limiting the further development of this method. To address this issue, this paper proposes a method for pretreating the slurry combined with sand prior to vacuum consolidation. This method partially replaces the fine particles with sand to reduce the formation of soil columns. Two groups of vacuum preloading tests were performed to investigate the effect of sand content and sand grain size on the vacuum consolidation of dredged slurry. The test results revealed that for a given sand grain size, increasing the sand content of the sand–slurry mixture increased the pore water drainage and accelerated the dissipation of pore water pressure, thereby increasing the vane shear strength. In contrast, for a constant sand content, the samples containing coarse sand exhibited increased pore water drainage and accelerated dissipation of pore water pressure, thereby increasing the vane shear strength of the soil.  相似文献   

珠江三角洲海相沉积软土压缩和剪切变形特性试验研究   总被引：3，自引：0，他引：3       下载免费PDF全文

张岩  耿济世  毛磊  刘芙荣 《地震工程学报》2018,40(4):745-751

为了研究近代海相沉积软土的变形特征,本文对珠江三角洲河口地区的全新世海相沉积的软土进行了室内单轴压缩与不同围压下作用下的三轴固结不排水(CU)、不固结不排水(UU)的剪切试验。试验结果表明:原状土和重塑土样的孔隙比随压力的增大而下降,且与加压方式有密切关系,加压幅度越小,土的扰动破坏越小;原状土样固结系数随着压力增加而递减,整体近似符合指数函数分布,重塑土样固结系数随着压力增加逐渐增大,整体近似符合线性函数分布。在相同的固结压力下,原状土样的强度低于重塑土样的强度。土样的应力应变曲线为应变硬化型,且围压对重塑土的影响小于原状土。  相似文献   

地幔上涌对鄂尔多斯西缘岩石圈的改造:来自远震多尺度层析成像的证据   总被引：4，自引：1，他引：3       下载免费PDF全文

高翔  郭飚  陈九辉  刘启元  李顺成  李昱 《地球物理学报》2018,61(7):2736-2749

本文利用喜马拉雅二期科学探测台阵的678个地震台站及26个固定台站记录到的9，641个地震共约160000条远震P波走时数据，采用基于稀疏约束的多尺度层析成像方法，获得了鄂尔多斯西缘及邻区上地幔800 km深度范围内P波速度结构.结果显示，在东经104°附近阿拉善地块与鄂尔多斯盆地间存在岩石圈深度的构造边界，这表明阿拉善地块与鄂尔多斯可能分别从属于不同的大地构造单元.以北纬38°线为界，鄂尔多斯地块西缘在岩石圈范围内南北存在明显的速度差异，鄂尔多斯南部上地幔200~300 km深度范围显示为高速异常，而鄂尔多斯北部上地幔显示大面积的低速异常.这一现象表明，鄂尔多斯地块南北两部分经历了不同的构造演化过程.根据本文的结果可以进一步推断，由于青藏高原、阿拉善地块向东北方向推挤以及岩石圈的拆离引起的上地幔扰动导致了地幔上涌，上涌的热物质改造了鄂尔多斯西北缘地区的岩石圈，并使该区的岩石圈减薄.地幔上涌也可能是东经104°边界带和北纬38°构造带形成的深部动力学因素.  相似文献   

Analytical and empirical models for predicting the drift capacity of modern unreinforced masonry walls     

Bastian Valentin Wilding  Katrin Beyer 《地震工程与结构动力学》2018,47(10):2012-2031

Displacement‐based seismic assessment of buildings containing unreinforced masonry (URM) walls requires as input, among others, estimates of the in‐plane drift capacity at the considered limit states. Current codes assess the drift capacity of URM walls by means of empirical models with most codes relating the drift capacity to the failure mode and wall slenderness. Comparisons with experimental results show that such relationships result in large scatter and usually do not provide satisfactory predictions. The objective of this paper is to determine trends in drift capacities of modern URM walls from 61 experimental tests and to investigate whether analytical models could lead to more reliable estimates of the displacement capacity than the currently used empirical models. A recently developed analytical model for the prediction of the ultimate drift capacity for both shear and flexure controlled URM walls is introduced and simplified into an equation that is suitable for code implementation. The approach follows the idea of plastic hinge models for reinforced concrete or steel structures. It explicitly considers the influence of crushing due to flexural or shear failure in URM walls and takes into account the effect of kinematic and static boundary conditions on the drift capacity. Finally, the performance of the analytical model is benchmarked against the test data and other empirical formulations. It shows that it yields significantly better estimates than empirical models in current codes. The paper concludes with an investigation of the sensitivity of the ultimate drift capacity to the wall geometry, static, and kinematic boundary conditions.  相似文献   

海洋功能区划与海洋生态红线关系探讨          下载免费PDF全文

高月鑫  曾江宁  黄伟  陈全震  寿鹿  徐晓群 《海洋开发与管理》2018,35(1):33-39

海洋生态红线制度是我国"五位一体"文明建设的具体要求。为进一步在自然科学与人文科学的联结点上探求深入开展生态红线工作的可能性,文章对比了实施多年的海洋功能区划与历史新阶段提出的海洋生态保护红线的概念和内涵,剖析了两者之间的区别与联系,指出海洋功能区划与海洋生态红线区划在法律地位和管控制度等方面具有一致性,在划分目标、空间管理及划分方法上具有差异性,海洋功能区划以"使用"为主,海洋生态红线以"保护"引领。在此基础上,建议未来海洋生态红线工作的开展可从海洋功能区划借鉴经验,建立完善的管控评估制度,确立生态保护红线的优先地位,处理好海洋功能区划与海洋生态红线区划的关系。同时,海洋生态红线区划应以维持海洋生态系统结构稳定和提高海洋生态系统服务功能为目标,将区域资源环境承载力评估作为一项参考指标,限制低承载区的开发利用,保证海洋生态环境健康可持续发展。  相似文献   

PS测井在机场隧道地基勘查中的应用          下载免费PDF全文

范伟顺 《山东国土资源》2018,34(1)

PS测井技术是地震勘探方法之一,也是一种简便、快速、准确的原位测试技术。该文介绍了单孔法PS测井的原理及其在铁路工程勘察中的应用,主要包括根据等效剪切波,进行建筑抗震场地类别划分,铁路工程抗震场地类别划分。根据岩土动力学参数,达到评价岩体质量和划分围岩类别目的,利用剪切波速法估算岩土的承载力基本值。通过青岛机场隧道场地的工程实例说明了PS测井技术在岩土工程勘察设计中的应用情况及应用效果。  相似文献   

Character and origin of De Geer moraines in the Seacoast region of New Hampshire,USA          下载免费PDF全文

Samantha N. Sinclair  Joseph M. Licciardi  Seth W. Campbell  Brian M. Madore 《第四纪科学杂志》2018,33(2):225-237

  相似文献   

水源钻机在超深土层绳索取心钻进中的应用          下载免费PDF全文

杨联锋  段云星 《探矿工程》2020,47(11):44-50

山西省清徐县区域地质调查项目设计800、2000、3000 m科学钻探孔，以调查填补新生界底板埋深控制空白区，各孔钻入基岩30 m完钻。要求全孔取心，岩心采取率≮85%，岩心直径≮60 mm，采用塑料保护管采取原状岩样。针对超深软土层、各组地层特性及厚度未知、钻遇基岩完钻深度未知、大直径高保真全孔取心、项目价格远低于目前市场成本等难题，经过“水源钻机+大提钻取心+长裸眼孔段”实施800 m孔、“岩心钻机+绳索取心+套管固井”实施640 m参数对比孔，创新性使用“水源钻机+绳索取心+长裸眼孔段”工艺完成了2000 m孔的施工。该工艺岩心采取率达到93%，孔径和孔斜符合地质要求，为3000 m孔顺利施工打下了坚实的基础，为同类型项目提供了经验和借鉴。  相似文献   

基于圆柱多段拟合的隧道中轴线提取方法研究     

荆海峰  李广云  王力  杨文锋 《大地测量与地球动力学》2018,38(2):211-215

提出基于圆柱多段拟合的隧道中轴线提取方法。首先对隧道点云数据进行预处理，并将点云按隧道走向分成不同区段；然后对各区段依据轴线与表面点云法线垂直关系，提取精度较低的中轴线；最后对各区段利用圆柱多段拟合，提取精度较高的中轴线。实验表明，隧道中轴线的提取在一定的采样区间具有较高的稳定性，对直线和弯曲的圆形隧道有良好的适用性，算法可靠，精度较高。  相似文献